817-465-6902

Hot water heaters are one of a property’s toughest working appliances. Day or evening, it’s making perfectly heated water at any time when you want it. When it suddenly is no longer working adequately, many of us often overreact.

Fortunately a non-functioning water heater does not constantly indicate an expensive repair. Before making an emergency call to A Monsey & Son Plumbing, we suggest checking the trouble yourself first.

Cedar Hill Water Heater Repair Troubleshooting

Pilot Light CheckCedar Hill Water Heater Repair

For gas water heaters first eliminate the small panel which is found on the bottom of the system and check to notice if the pilot light is illuminated.
See if may relight in case it is not lit. If it remains lit, one will probably be able to hear that the water heater should begin working correctly once more. The pilot light may perhaps need cleaned out or the thermocouple may need replaced when the pilot light will definitely not remain lit.

Thermocouple Replacement

The term thermocouple may perhaps seem like a really complex term, but it’s a component on ones water heater that can easily be replaced. A Monsey & Son Plumbing would recommend having us conduct the replacement but the methods below are for instructional objectives.

Consult the owner’s handbook. It needs to have suggestions for the best ways to remove and change the thermocouple.
Turn off the gas before removing anything at all from the water heater.
Using the guidelines in your user’s guide, remove the thermocouple by separating it from both sides of the pilot light. The new thermocouple on the water heater is required to be cut to the correct length.
The gas may then be turned back on and test for leaks, then the pilot light may be lighted again.

Press the Water Heater Reset Button

For property owners with an electric water heater, discover the location of the reset button and press it till a click is heard.
If a click is definitely not heard, or it fails to restart the water heater, reset the breaker.
If a breaker reset doesn’t do the technique, the thermostat may well require being replaced.

Thermostat Replacement

Both the power to the water heater and the switch on the breaker will require being turned off. Basic safety with electricity needs to be used!
Use the owner’s handbook to find the thermostat wires, then separate them.
After taking out the thermostat we will evaluate to observe its problem. If it is faulty, we will have to change it.

Heating Element Replacement

While the power is still off, the access panel on the water heater may be removed.
The terminal screws may be loosened and the wires may be drawn far from the heating element.
We would next test each part of the element to verify if they are defective, and replace them as required.

These water heater troubleshooting techniques ought to help get ones heater going once more. A Monsey & Son Plumbing is definitely here to assist, and so don’t wait to contact us today for any Water Heater Repair Cedar Hill TX help.

Click to print a PDF of this article.